top of page
Tekniker

P0714 fault-error code TRANSMISSION OIL TEMPERATURE SENSOR CIRCUIT INTERMITTENT

Updated: Sep 23

What is the P0714 Fault-Error Code ?

 

The P0714 fault-error code is "Transmission Fluid Temperature Sensor Circuit Intermittent".

 

When this code appears, it typically indicates an intermittent problem with the Transmission Fluid Temperature (TFT) sensor circuit. The TFT sensor measures the temperature of the transmission fluid and sends this information to the Engine Control Module (ECM) or Transmission Control Module (TCM). An intermittent error means that the problem is not constant and may occur intermittently.

 

What are the symptoms of P0714 Fault-Error Code ?

 

When a P0714 fault-error code is detected, a variety of symptoms may occur. Some potential symptoms include:

 

Check Engine Light On: The most common indication of the P0714 trouble code is the check engine light on your vehicle's dashboard. The CEL illuminates when the engine control module (ECM) or transmission control module (TCM) detects a fault with the transmission fluid temperature sensor circuit.

 



Intermittent Transmission Shifting Issues: Intermittent erratic or abnormal shifting behavior can occur due to inaccurate transmission fluid temperature readings. The transmission may delay shifting, shift harshly, or fail to shift into certain gears properly.

 

Transmission Overheat Warning: On some vehicles, a specific warning light or message may indicate that the transmission is overheating. Intermittent problems with the TFT sensor circuitry can trigger this warning intermittently, alerting the driver to potential problems with transmission fluid temperature.

 



Transmission Slippage: Intermittent issues with the TFT sensor circuitry can cause the transmission to slip, where the transmission is unable to properly maintain power and momentum, especially under load or during acceleration.

 

Other Transmission-Related Problems: Depending on the severity of the problem and the vehicle's specific transmission system, other transmission-related symptoms such as abnormal noises, rough shifting, or transmission hesitation may occur intermittently.

 



What could be the causes of the P0714 Fault/Error Code ?

 

There are several possible causes that can trigger the P0714 fault/error code:

 

Faulty Transmission Fluid Temperature (TFT) Sensor: A faulty TFT sensor is one of the most common causes of code P0714. The sensor may intermittently fail to provide accurate temperature readings due to internal electronic issues, wear, damage, or poor connections.

 

Wiring Issues: Intermittent faults in the wiring harness associated with the TFT sensor circuit can cause fluctuations in the sensor's signal. This can include loose connections, corroded connectors, damaged wiring, or wiring rubbing against other components.

 



Poor Ground Connection: A poor ground connection in the TFT sensor circuit can cause intermittent problems with signal transmission and cause code P0714 to appear. Make sure all ground connections are clean, tight and free of corrosion.

 

Faulty ECM or TCM: In rare cases, a problem with the engine control module (ECM) or transmission control module (TCM) can cause intermittent communication or signal processing errors with the TFT sensor circuit.

 



Environmental Factors: Extreme temperatures or conditions such as high heat, humidity or moisture can cause intermittent faults in the TFT sensor circuit. These conditions can compromise electrical connections or cause the sensors to fail.

 

Intermittent Shorts or Opens: Intermittent shorts or opens in the wiring harness or sensor connections can cause intermittent faults in the TFT sensor circuit.

 



Component Age or Wear: Over time, components within the TFT sensor circuit such as connectors, wires, and sensor elements can deteriorate or wear out, leading to intermittent problems.

 

Vibration or Movement: Excessive vibration or movement of the vehicle, especially in areas where cables are routed, can cause disconnects or damage to TFT sensor circuit components.




 

What Steps Should Be Followed To Resolve P0714 Fault-Error Code ?

 

To resolve the P0714 fault/error code, follow these steps:

 

Read Code: Use an OBD-II scanner to retrieve trouble code P0714 and any other related codes stored in the vehicle's engine control module (ECM) or transmission control module (TCM). Write down any codes present as they may provide additional information about the problem.

 

Check Transmission Fluid Level: Check the transmission fluid level and condition. Make sure the fluid level is within the recommended range specified in the vehicle's service manual and that the fluid is clean and free of contamination.

 



Inspect TFT Sensor and Wiring: Locate the Transmission Fluid Temperature (TFT) sensor and inspect for any signs of damage or corrosion. Check the wiring harness associated with the TFT sensor for any damage, breaks, or loose connections.

 

Test TFT Sensor Voltage: With the engine running and the transmission in gear, use a multimeter to test the voltage output of the TFT sensor. Compare the measured voltage readings to the specifications stated in the vehicle's service manual.

 

Check ECM/TCM Communication: Use diagnostic tools to scan the ECM and TCM for any internal faults or communication issues with the TFT sensor circuit. Ensure that the modules are receiving and transmitting signals properly.

 



Inspect Ground Connections: Check all ground connections related to the TFT sensor circuit for cleanliness, leaks, and corrosion. Poor ground connections can cause intermittent faults.

 

Repair or Replace Faulty Components: Depending on your diagnosis, repair or replace any faulty components detected during inspection, such as the TFT sensor, wiring harness, connectors, or ECM/TCM.

 



Clear Codes and Test Drive: After completing repairs, clear any trouble codes stored in the ECM or TCM using an OBD-II scanner. Take the vehicle for a test drive to ensure the P0714 code does not return and the transmission is functioning properly.

 

Recurrence Monitor: Pay attention to vehicle performance and check for a recurrence of code P0714. If the code returns, recheck all components and wiring to identify any issues you may have missed.

 


P0714

What Are the Long-Term Effects of the P0714 Fault-Error Code ?

 

 

Long-term effects of fault/error code P0714 include:

 

Transmission Damage: Intermittent issues with the TFT sensor circuit can lead to inaccurate transmission fluid temperature readings, which can affect transmission operation. Extended operation with inaccurate temperature readings can lead to improper shifting, increased friction, and accelerated wear and tear on transmission components. This can eventually lead to transmission failure if left unaddressed.

 



Transmission Overheating : Inaccurate TFT sensor readings may not detect true transmission overheating. Over time, prolonged transmission overheating can damage internal components, leading to transmission failure or reduced transmission life.

 

Decreased Fuel Efficiency: Intermittent problems with the TFT sensor circuit can affect transmission efficiency and cause fuel efficiency to decrease over time due to poor transmission performance.

 



Transmission Slippage: A faulty TFT sensor circuit can cause intermittent transmission slippage, where the transmission fails to properly maintain power and momentum, especially under load or during acceleration. Continuing to slip can cause further damage to transmission components.

 

Safety Concerns: Faulty transmission components, such as the TFT sensor, can compromise the drivability and safety of a vehicle. Erratic shifting, delayed engagement, or other transmission-related issues can affect the vehicle’s handling and response, potentially leading to unsafe driving conditions.

 



Increased Repair Costs: Ignoring or delaying repairs for a P0714 trouble code can lead to more significant transmission issues over time, resulting in higher repair costs. Addressing the issue promptly can help prevent further damage and reduce overall repair costs.


In general, it is very important to address a P0714 trouble code immediately to prevent any potential long-term effects on the vehicle's transmission, driveability, fuel efficiency, and safety. Ignoring the problem or delaying repairs could lead to more significant problems and higher repair costs in the future.



コメント


bottom of page